DPT, Pliers-Shaped Tool for Snakes and Waste, Reptile Clamp, Silver, Size 150 Cm

Item No.: DPTO-0108
Item name: The snake catcher
Size: 10.4*36.8cm

Features: Design for catching snake

Instructions:
Cautions!
Please strictly observe the using occasions and operation instructions, otherwise it will cause the danger of injury and electric shock.

1. This product is made of metal, with electrical conductivity, please do not use in the place the risk of electric shock.
2. When using, please do not put any part of your hand or body inside the clip mouth, which is easily got hurt
3. When catching Snake, if there are branches, wood and other debris will cause the snake off, therefore, in the context of working, please be careful attention to pets, especially children near
4. Before snatch, please wear protective gloves, shoes, helmets, etc., good protective measures, pay attention to safety
5. During use, pay attention to feet and the surrounding environment, roofs, ladders and other unsafe places, please do not work
6. After use, please close the mouth and lock the safety barrier, keep it out of the reach of children's safekeeping

Cautions！Must be observe
1. The purpose of this product is used to capture snakes, in addition, please do not make other uses
2. Please check and confirm the product performance and components must be safety normal, non-destructive before use.

Design for catching snake

Parts Name
1. Up folder
2. Under folder
3. Telescopic button switch
4. Aluminum rod
5. Handle

Using instructions:
1. Gently hold the handle, force the head jaw upward, in accordance with the direction of the arrow, release the safety shield, open the mouth
2. In the meantime, when stopping work, please fasten the safety baffle to prevent the mouth from opening
3. After use, anti-rust oil in the port part of the map, close the mouth, while the handle on the safety barrier lock, and safekeeping
4. Telescopic key switch, press the arrow direction, first press the control key, and then pull up the telescopic aluminum alloy rod, adjusted to fit the length and calibration of the delivery gap is correct, put down the control key, confirm the convergence, can use
5. Please put oblique clip mouth, the snakehead is located in the clip mouth, hold the handle, you can capture